Slide 8" or more of pipe through hole in puller.
Allow pipe to fold over as it follows bullet into ground.
At end of pull, continue pulling until cut end of pipe is out of ground and slide pipe out of hole to detach.

2" bullet or larger recommended.
Slide one pipe into each hole of Dual Pipe Puller.
Follow instructions above.

Insert wire through bottom hole and twist wire 4 to 5 times.
When pulling wire with mainline, insert mainline in same hole as wire. (this will protect wire during pull)

 

Dual Pipe Puller - 1" and below
Use with 1" PVC (Class 200 / SCH 40) and Poly pipe. 1/4" swing pipe. Control wire.
Can pull one or two pipes at a time.

 

Part #  NC-1.5
1.25" - 1.5" Pipe Puller
Use with 1.25" to 1.5"  PVC (class 200 / SCH 40) and Poly pipe.

 

Part #  NC-2.0
2" Pipe Puller
Use with 2" PVC (Class 200 / SCH 40) and Poly pipe.